Tree removal can be extremely dangerous and even life-threatening. It really is never recommended to eliminate a tree by yourself unless this is a small one that you are confident it is possible to handle safely. Otherwise, tree removal ought to be left in the hands of professionally-trained and equipped tree service contractors. When you have a tree on your property that's fairly small, but needs to be removed, it is possible to possible do-it-yourself with the proper tools, knowledge, and planning.
Tree Removal Preparation
Proper preparation for small tree removal involves gathering all your needed supplies, and also, a thorough inspection of the tree. Look to see if the tree leans one way or the other, and plan an escape route in case it does not fall how you expect it to fall. Also, examine whether or not there are any obstacles in any direction of the tree, including vehicles, structures, along with other trees. In case you are sure there's enough safe clearance for the tree to fall, then you can move ahead to gathering your equipment and tools. This includes:
Safety Gear (Utility gloves, goggles, hard hat, steel toe boots, etc.)
Chainsaw
Ax or Hacksaw
Ladder
Rope
Wedges
First Aid Kit
TO ELIMINATE a Tree
Once you have all your equipment and supplies, you can get started removing the tree. First, use your ax to knock on the bark several times, and in a few different places, to learn how solid or hollow the tree is. Getting a less dense area to cut will be easier. Next, plan which side of the tree you need to make your cut. Look to see where in fact the tree naturally leans; it is better to cut a tree in the direction where it really wants to naturally fall. Be certain the area where the tree drops is level so the tree will not roll or bounce after it falls.
Create a horizontal cut at hip-height, and about 1/3rd into the tree. Do this privately of the tree where you want it to fall. If you want the tree to fall to the proper, you must cause you to cut on a single side so that it falls inward, towards the cut. The tree will fall perpendicular to your horizontal cut. Your second cut should develop a wedge into the tree. So make the second cut at an angle from the original cut. It should appear to be a lemon wedge.
Your third cut is named a back cut, and is should be made on the contrary side of one's wedge cut. This cut will make the tree fall over on the side of one's wedge cut. Make it about 1.5 inches above the wedge cut, and as thick as possible. Also you can use a wedge to prevent the tree from settling onto the chainsaw. Add more wedges as necessary until the tree begins to fall. You can find out more run! But do not turn your back on the tree as it falls.